Dollar Tree Pumpkin Wreath DIY with Dollar Tree Flowers

Step-by-step instructions on how to make a stunning pumpkin wreath for fall with a Dollar Tree pumpkin wreath form and Dollar Tree flowers.

Flip over the pumpkin wreath form and place the burlap fabric on the backside. You will be wrapping the fabric around the pumpkin wreath form. Eyeball it and then use scissors to remove the excess fabric.
Add hot glue in small sections onto the wreath form and then pull the burlap fabric over the top of it.
Repeat this until the entire wreath form is covered by the burlap. Trim any excess fabric if you wish, but it is not necessary as it won’t be seen through the wreath.
Save a small section of the burlap about 3 inches by 4 inches to make the stem on the top.
Using wire cutters, cut the sunflowers from their stem and leave about an inch to an inch and a half of the original stem.
Add hot glue to the backside of the flower and push the stem through the burlap fabric (use the holes already in the fabric).
Repeat this process to cover the entire pumpkin wreath form.
It should take the entire 10 bunches of sunflowers.
Next double over the leftover piece of burlap fabric. Place the center of the ribbon on the wreath stem and add a dab of hot glue to the wire so it is secure. Fold the backsides over each other and add hot glue to secure.
Finally, add a leaf from the flowers to the stem with hot glue.
Embellish the Pumpkin